Installing The Transport Wheel Shafts; Installing The Transport Wheels - Toro Greensmaster 800 Operator's Manual

Figure 7
1. Bolt
2. Spring stud
2. Hook the spring into the hole in the spring
bracket and onto the spring stud while aligning
the kickstand with the mounting holes in the rear
frame (Figure 8).
Figure 8
1. Kickstand
2. Spring bracket
3. Mount the kickstand to each side of the frame
with a bolt, lock washer, spacer, flat washer, and
locknut (Figure 8).
4. Position the spacer in the kickstand mounting
hole.
g017948
3. Washer
4. Flange–head nut
g007594
3. Spring stud
4. Spring
3
Installing the Transport
Wheel Shafts
Models 04055 and 04056 Only
Parts needed for this procedure:
1 Right wheel shaft
1 Left wheel shaft
Procedure
1. Push the kickstand down with your foot and pull
up on the handle to support the machine on the
kickstand.
2. Apply thread-locking adhesive to the threads of
the wheel shafts.
3. Thread the right wheel shaft into the drive pulley
on the right side of the machine
Note:
The right wheel shaft has left-hand
threads.
1. Right wheel shaft
4. Torque the shaft to 88 to 101 N∙m (65 to 75 ft-lb).
5. Repeat steps
shaft to the left side of the machine.
10
(Figure
Figure 9
2 through 4 to install the left wheel
9).
g007595