Vertex Standard FT-857 Operating Manual page 67

Default: OFF
MENU MODE No 008 [ARTS BEEP]
Function: Selects the ARTS beep mode.
Available Values: OFF/RANGE/ALL
Default: RANGE
OFF: No alert beeps sound; you must look at the display to determine current ARTS status.
RANGE: A high tone beep will sound when the transceiver first detects that you are within range, and a low beep will
sound when the other station goes out of range.
ALL: A high tone beep will sound every time a polling transmission is received from the other station, and a low
beep will sound once when the other station goes out of range.
MENU MODE No 009 [ARTS ID]
Function: Enables/disables the CW identifier during ARTS operation.
Available Values: ON/OFF
Default: OFF
MENU MODE No 010 [ARTS IDW]
Function: Stores your callsign into the CW identifier. Up to ten characters may be stored. The storage procedure is as
follows:
1. Press the MEM/VFO CH knob momentarily to initiate callsign storage (the first character location of
the callsign will be underlined).
2. Rotate the DIAL knob to select the first letter/number of your callsign, then rotate the MEM/VFO CH knob one click
clockwise to save the first letter/number and move to the next entry position.
3. Repeat the previous step as many times as necessary to complete your callsign.
4. Press the MEM/VFO CH knob to save your completed callsign and exit.
Default: YAESU
MENU MODE No 011 [BEACON TEXT 1]
Function: Stores the message for the Beacon. Up to 40 characters may be stored. The storage procedure is as follows:
1. Press and hold in the [F] key for one second to enter the Menu mode.
2. Rotate the MEM/VFO CH knob to select Menu Mode No-011 [BEACON TEXT 1].
3. Press the MEM/VFO CH knob to enable storage of the Beacon Text (the first character location will be underlined).
4. Rotate the DIAL to select the first character (number or letter) in the Beacon Text you wish to store, then rotate the
67
FCC ID: K66FT-857
Operating Manual
Vertex Standard Co., Ltd.