Table of Contents
Advertisement
020
CAT/LIN/TUN
021
CLAR DIAL SEL
022
CW
AUTO
MODE
023
CW BFO
024
CW DELAY
025
CW KEY REV
026
CW PADDLE
027
CW PITCH
028
CW QSK
029
CW SIDE TONE
030
CW SPEED
031
CW TRAINING
032
CW WEIGHT
033
DCS CODE
034
DCS INV
035
DIAL STEP
036
DIG DISP
Selects the device which is connected to the CAT/LINEAR
jack on the rear panel.
Defines the "control" knob to be used for setting of the
clarifier offset frequency.
Selects whether the KEY jack shall be "Enabled" or
"Disabled" while using the SSB/FM modes.
Sets the CW carrier oscillator injection side on the CW mode.
Sets the receiver recovery time during pseudo-VOX CW
semi-break-in operation.
Sets the keyer paddle's wiring configuration.
Enables/disables
CW
keying
[UP]/[DWN] keys.
Setting of the pitch of the CW sidetone, BFO offset, and CW
filter center frequencies.
Selects the time delay between when the PTT is keyed and the
carrier is transmitted during QSK operation when using the
internal keyer.
Setting of the CW sidetone volume level.
Sets the sending speed for the built-in Electronic keyer.
Sends random Morse Code five-character groups via the
sidetone.
Sets the Dot:Dash ratio for the built-in electronic keyer.
Setting of the DCS code.
Selects "Normal" or "Inverted" DCS coding.
Setting of the DIAL knob's tuning speed.
Defines the displayed frequency offset during DIG (USER-L
or USER-U) mode operation.
CAT/LINEAR/
TUNER
CLAR, M/V, MAIN
ON/OFF
USB/LSB/AUTO
FULL/
30 ~ 3000 msec
NORMAL/
REVERSE
by
the
microphone's
ELEKEY/MICKEY
400 ~ 800 Hz
10/15/20/25/30 ms
0 ~ 100
4 ~ 60 wpm
(1wpm/step)/
20 ~ 300 cpm
(5cpm/step)
N, A, AN
1:2.5 ~ 1:4.5
104
codes
Tn-Rn/Tn-Riv/
Tiv-Rn/Tiv-Riv
FINE/COARSE
–3000 ~ +3000 Hz
62
FCC ID: K66FT-857
Operating Manual
CAT
CLAR
OFF
USB
250 msec
NORMAL
ELEKEY
700 Hz
10 ms
550
12
wpm(60
cpm)
N
1:3.0
Standard
DCS
023
Tn-Rn
FINE
0 Hz
Vertex Standard Co., Ltd.
Advertisement
Table of Contents
