Do you have a question about the ST-600D and is the answer not in the manual?
Questions and answers
Mustapha Mounir
April 24, 2025
how to replace the belts plz?
1 comments:
Mr. Anderson
May 12, 2025
To replace the belts on an Elmo ST-600D:
1. Unplug the projector from the power source. 2. Open the projector casing to access the belt area. 3. Remove the old, broken belts. 4. Install the new belts in the correct positions, ensuring proper alignment. 5. Be cautious around the transformer area, as one user reported the take-up reel belt touching the transformer. 6. Ensure the belts are not twisted and have appropriate tension. 7. Reassemble the casing and test the projector.
Note: If the belt touches the transformer, verify that all components are in their original positions and not misaligned.
This answer is automatically generated
Frank Johansson
January 29, 2025
Hur byter man drivrem på en Elmo ST-600 D
1 comments:
Mr. Anderson
May 14, 2025
To replace the drive belt on an Elmo ST-600D:
1. Thoroughly remove the old belt, including any tar or residue. 2. Clean the pulley and surrounding parts with alcohol to remove all residue. 3. Ensure all surfaces are dry and free from grease or oil, as these can cause the new belt to slip. 4. Install the new belt once the area is clean and dry.
These steps help ensure optimal projector performance and extend the life of the new belt.
Need help?
Do you have a question about the ST-600D and is the answer not in the manual?
Questions and answers
how to replace the belts plz?
To replace the belts on an Elmo ST-600D:
1. Unplug the projector from the power source.
2. Open the projector casing to access the belt area.
3. Remove the old, broken belts.
4. Install the new belts in the correct positions, ensuring proper alignment.
5. Be cautious around the transformer area, as one user reported the take-up reel belt touching the transformer.
6. Ensure the belts are not twisted and have appropriate tension.
7. Reassemble the casing and test the projector.
Note: If the belt touches the transformer, verify that all components are in their original positions and not misaligned.
This answer is automatically generated
Hur byter man drivrem på en Elmo ST-600 D
To replace the drive belt on an Elmo ST-600D:
1. Thoroughly remove the old belt, including any tar or residue.
2. Clean the pulley and surrounding parts with alcohol to remove all residue.
3. Ensure all surfaces are dry and free from grease or oil, as these can cause the new belt to slip.
4. Install the new belt once the area is clean and dry.
These steps help ensure optimal projector performance and extend the life of the new belt.
This answer is automatically generated