Ping Test
RF Keying Test
Spectrum Graph
60
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8461-MDS-UP-SD9-MS2ES-Upgrade-Key-SD9-MS-to-SD9-ES.aspx
A connectivity test to a specific destination address may be performed
using the radio's Ping Test screen.
•
Destination Address
ping tested.
•
—Enter the number of pings to send across the radio link.
Count
•
—Enter the number of bytes in each ping.
Bytes
•
—Use this box to specify how long (in seconds) between
Interval
ping transmissions after a response is received.
•
—Use this box to specify how long (in seconds) to wait
Timeout
for a ping response before a timeout occurs.
The RF Keying Test screen provides a way to place the transmitter on
the air to check the measured RF power output, measure reflected power
from an antenna system, or to provide a signal at a receiving station so
that RSSI can be checked.
•
—Set to
Key Radio
it. The Commit Configuration button must be clicked to apply the
setting.
•
Measured RF Power
sured power output of the transmitter.
A unique feature of the transceiver is the ability to view the RF spectrum
above and below the operating frequency using its built-in Spectrum
Graph. Often, this can assist in diagnosing the cause of interference, or
to view other signals near your operating frequency.
SD Series Technical Manual
—Enter the IP Address of the other radio being
to enable the RF keying test;
ON
—Provides an indication (in dBm) of the mea-
MDS 05-4846A01, Rev. D
to disable
OFF