Using The Remote Management Wizard; Getting An Overview Of Radio Settings; Initial Startup & Checkout - GE MDS SD Series Technical Manual

Using the Remote
Management Wizard
Getting an Overview
of Radio Settings
MDS 05-4846A01, Rev. D
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8461-MDS-UP-SD9-MS2ES-Upgrade-Key-SD9-MS-to-SD9-ES.aspx
Figure 22. Basic Setup Wizard
5. At the conclusion of the wizard, click
complete for the connected radio. Log out of the Device Manager by
clicking in the upper right hand side of the screen. If desired,
Logout
you may proceed with the additional functions described below.
To program the key settings of other radios installed in the wireless net-
work, select
Setup Wizards>>Remote Management
contained in that tool. At the conclusion of the wizard, click
, followed by
figuration Done
To get a top-level view of the key settings and operating parameters for
the radio, select
Overview
log out of the Device Manager by clicking
side of the screen.
5.2 Initial Startup & Checkout
In-service operation of the transceiver is completely automatic. Once
the unit has been properly installed and configured as described above,
operator actions are limited to observing the front panel LED indicators
for proper operation.
If all parameters are correctly set, operation of the radio can be started
by following these steps:
1. Apply DC power.
2. Observe the LED status panel for proper indications (Table 10).
SD Series Technical Manual
Invisible place holder
. Configuration is now
Done
, and follow the prompts
. Remote configuration is now complete.
and a screen will be displayed. When finished,
in the upper right hand
Logout
Commit Con-
29