Diagnostic Settings
44
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8461-MDS-UP-SD9-MS2ES-Upgrade-Key-SD9-MS-to-SD9-ES.aspx
•
—This parameter identifies the radio in the wireless network
Unit #
with a specific ID during diagnostic sessions.
•
—This setting identifies the radio as either a Node, Root,
Dlink Type
Repeater, Peer, or Gate. Each of these are operating modes of the
transceiver with respect to diagnostic/management activities.
(See "Performing Network-Wide Remote Diagnostics" on
Page 75 for details.
•
—This item is used to enable or disable diagnostics
Dlink Status
functionality. Setting it to
diagnostic link protocol (DLINK) over the radio's
ment port.
•
—This setting determines the COM1 serial data
Dlink Baud Rate
diagnostics communication rate in bits-per-second (bps).
•
—This setting enables DLINK over Ethernet via
Dlink TCP Access
TCP. This allows an external NMS to manage the radio without
tieing up a serial port.
•
—This setting specifies the TCP port for DLINK
Dlink TCP Port
communication. The address for Ethernet-based DLINK commu-
nication is given by the radio's IP address (from the general set-
tings menu) and the port number specified here.
SD Series Technical Manual
configures the radio to pass the
ON
COM1
MDS 05-4846A01, Rev. D
manage-