Table of Contents
Advertisement
GeoSIG Ltd
AC-23 Accelerometer Manual
2
Mounting
Small size and single bolt attachment allow the AC-2X to be easily installed saving installation time. Levelling
is accomplished via three-point levelling screws.
a
Do not overtighten the three-point levelling mechanism. This may damage the sensor.
*
+0.2
20.3
-0.2
15.0
6.0
The accelerometers must be firmly mounted to a surface and levelled, as the application requires. Check to
be sure that the accelerometer is aligned to produce the desired output signals. Acceleration in the direction
indicated on the case will produce a positive output signal. The orientation definitions as shipped are:
X = East, Y = North and Z = Vertical (Up).
The accelerometer has single-bolt, 3-feet-levelling mechanism.
Figure 2, AC-2X housing
165.0
181.5
195.0
152.0
76.0
ø 15
ø9
165.0
Figure 3, Sensor housing dimensions
GS_AC-23_UserManual_V14.docx/27.05.2019
41.0
15.0
Minimum Space Allowance for the Connector and Cable:
*
3 x M6
Sensor with Connector: 300 mm from sensor housing
Sensor with Cable Inlet: 200 mm from sensor housin
6.0
Page 5
40.0
20.0
15.0
Advertisement
Table of Contents
