Installed Options - CH A1.5 User Manual

RESET ALL SETTINGS Reset
Serial number
SERIAL NUMBER
SHORTCUTS Default shortcuts None
PROTECTION Disabled
Enabled
NETWORK Reset
KNOWLEDGE
4.3.1.5

INSTALLED OPTIONS

The following table details the parameters of the INSTALLED OPTIONS menu:
PARAMETER PARAMETER VALUES
ANALOG IN 1, 2 Analog in left, Analog in right, - At least 1x ANALOG_IN parameters are Read Only
Rev 1.0
None
None
None
None
Details of FACTORY SETTINGS menu parameters
The A1.5 SETUP >> OPTIONS menu provides read-only information about
installed slot-in boards. Details are:
- ANALOG IN 1:
- ANALOG IN 2:
Each slot indicates the type of board it handles. A '-' indicates that the slot is
currently unpopulated.
REQUIRED OPTIONS
Details of INSTALLED OPTIONS menu parameters
A1.5 User Manual
USB flash drive with a valid set of firmware must be inserted in
the back panel USB port
Selecting 'Reset' returns the A1.5 to its factory settings.
Serial number indicates the serial number of the A1.5. Format is
xxxx10nn. This parameter is read only.
Selecting 'Default Mapping' returns the A1.5's Shortcuts to their
factory settings. Factory settings are detailed in the Specifications
section.
Output short-circuit, output-DC, over-heat and amplifier-fault
detection circuitry protect both the amplifier and the connected
loudspeakers. In some regions of the world, the power
distribution grid can be so polluted that spurious power grid noise
can trig false error, thus muting or powering down the amplifier.
In such extreme cases, and if it is of major importance that the
A1.5 runs uninterrupted, protections can be temporary disabled
by the end user, at his own risk.
Clears the A1.5's memory of other CH Precision devices it has
discovered through the TCP/UDP proprietary protocol.
Input board installed in Slot 1
Input board installed in Slot 2
REMARKS
37