E-line VEL90F User And Installer Instruction Manual page 7

When the appliance is in standby mode, the remote control will show the current time,
battery level and operating mode at the top of the screen.
Timer Mode
In timer mode the appliance can be set to operate and turn off at a set of pre-
programmed times.
Timer Mode - Setting the Day/Time
 Press MODE to choose
 Press +/- buttons to select a date from 'MON' to 'SUN'.
 When correct day is blinking press </> buttons to select the hour setting. The hour
setting will now blink – press the +/- buttons to select the correct hour.
 When the correct hour is blinking press </> buttons to select the minute setting. The
minute setting will now blink – press the +/- buttons to select the correct minute.
Timer Mode - Setting the Programme
 Press MODE to choose
 Press +/- buttons to highlight 'ON ASC' above the
mode. Press > button to move to the next step.
 Press MODE button to highlight the day to set a programmed start/end time to
operate the heater. Press +/- to cycle between 'MON' and 'SUN'. When the correct
day is blinking press </> to adjust the start time setting.
 The word 'START' and the
select the correct hour. Press > to move to the next step.
 The 'START' and minutes will now blink on the screen. Press +/- buttons to select the
correct minute. Press > to move to the next step.
 The word 'END' and the
the correct hour. Press > to move to the next step.
 The 'END' and minutes will now blink on the screen. Press +/- buttons to select the
correct minute. Press > to move to the next step.
USER INSTRUCTIONS - OPERATION
. 'MON' will blink on the screen.
. 'OFF' will blink under the
will now blink on the screen. Press +/- buttons to
will now blink on the screen. Press +/- buttons to select
icon.
icon. This switches to smart