E-line VEL90F User And Installer Instruction Manual page 6

Remote Control
When the appliance is in standby mode, the remote control will show the current time,
battery level and operating mode at the top of the screen.
The appliance can be turned on by pressing the POWER/STANDBY button on the remote
control. This will turn on the flame effect only. The desired operating mode can then
be selected.
Flame Effect and Heating Mode
 Press the MODE button to choose
adjusted. The
 When the appliance is turned on, the flame is at its brightest setting. Press </> buttons
to adjust the brightness level.
 Press the +/- buttons to adjust the heating between Level 1 (0.75kW) and Level 2
(1.50kW)
Level 1
Level 2
Temperature Mode (Thermostatic)
In temperature mode, a specific temperature limit can be set so that the appliance
automatically turns off the heater when the room temperature reaches that limit, after
which the appliance will continue to operate in flame effect mode only. The temperature
range that can be set is:
Fahrenheit 65-95°F
Centigrade 18-35°C
 Press MODE to choose
and Centigrade settings.
 Press +/- buttons to select the required temperature limit and activate the heater.
 For the heater to operate in Temperature mode, the set temperature limit must be
higher than the current room temperature. If the temperature limit is set lower than the
current room temperature then the appliance will operate on flame effect mode only.
NOTE: when appliance is next turned on, the temperature setting will be the same as the
previous time the appliance was used.
USER INSTRUCTIONS - OPERATION
symbol will show in the top left of the display.
. Continue to press MODE to choose between Fahrenheit
. The flame and heating function can now be