E-line VEL90F User And Installer Instruction Manual page 13

Before proceeding it is advised that you test the appliance for operation before
continuing with installation. Pay particular attention to the arrangement of vermiculite
gravel around the contact points with the ceramic logs. Experiment with small gaps in the
gravel to allow the flickering orange light below to shine through.
Step 8
Replace the glass referring to the process
detailed in Steps 2 & 3. If you are using a
VEL90F (front glass only) or VEL90C (front
and 1 side glass only) you do not need to
replace the side glass where a steel side
panel will be replaced. To replace the
steel side panel on these models please
refer to the process detailed in Step 1.
For glass sided appliances (VEL90P and
VEL90C) you must fit the steel glass
finishing edges around the side glass
panels. These are fitted using the screws
from the steel side panels.
Step 9
Build studwork chimney breast. When building a studwork chimney breast ensure that the
appliance does not bear the weight of the finished wall. Use a header if required.
Allow for the finished face of the chimney breast when considering the depth of the
structure.
Ensure that the power lead is connected to the appliance and to a mains socket that is
fully accessible at all times.
IMPORTANT: When building the stud framework, ensure that there is a clearance gap
around all sides of the appliance of at least 60mm to allow for critical airflow.
IMPORTANT: Do not seal the appliance into the chimney breast as this can impact upon
the airflow. When boarding to the appliance, leave a 5mm gap. This gap will be
covered by the glass finishing edges.
INSTALLATION
Fitting side glass
finishing edges