Table of Contents
Advertisement
INSTALLATION
Shelf/Plinth Fitting
When installing a shelf use the long fireplace fixing bracket and two short fireplace fixing
brackets. These are screwed to appliance and can be adjusted in height to suite different
thicknesses of material.
Offer the shelf up to the appliance, sliding onto the fireplace fixing brackets. Secure the
shelf by screwing through the holes on the fireplace fixing brackets into the underside of
the shelf. Ensure that the screws are the correct size to avoid penetration of the top
surface of the shelf.
TROUBLESHOOTING
No power to the appliance – Check that the appliance is connected to the mains supply
and switched on. Check the remote control batteries.
Flame effect working but no heat – Determine if Temperature Mode is activated and that
the set temperature is higher than the current room temperature. Check for
blockages/obstructions around air intakes as the safety cut-out may have activated.
Clear any blockages/obstructions. Switch appliance off at the mains, wait for 1 minute
then switch back on. These actions should reset the safety feature.
Noise during operation – It is normal for some noise during operation due to moving
mechanical components and air movement.
Advertisement
Table of Contents
