Replace The Front Spring Armor Plate - Crown C48-2+2 Owner's Manual And Service Manual

Hide thumbs

Table Of Contents

Table of Contents

Tool

Speedness spanner,1/2"couplier

3/4"jacket,1/2"couplier

9/16"Spanner

3/4" Spanner

Plastic hammerhead

5/8"Spanner

11/16"Spanner

9/16" jacket,1/2"couplier

5/8" jacket,1/2"couplier

Torque wrench,1/2"couplier

1) Loosen the front wheel, then jack up the cart.

2) Remove the spare parts(1,4,5) which connect

with the shock absorber(2)

3) Remove the locknut(6) ,washer(8,9), screw(7),

thrust washer(11),core pin(12) and keep them

well.

4) Remove the spare parts of the other side as

above method.

5) Remove the spare parts from the connection

rack assembly(16) and keep them well, then

fix the rack assembly on the armor plate spring.

6) Remove the three

five locknuts on the front beam, and the locknuts can be used again.

7) Remove other connection spare parts separately and keep them well for assembling again.

8) The steps for assembling the beam is opposite to remove it and the connection spare parts(18-

24,28)should be assembled at the former position.

9) The torque of （13~15，18~21，28）is 35-50N.M.

10) Assemble the thrust pad(11), core pin(12), claw, washer(9) and screw(7) and the torque for

fastening the locknut is 56-60N.M.

11) Fasten the connector of the shock absorber, and the

locknut on the nether-end should be fastened to let the

rubber cushion and

shock absorber keep parallel.

12) After assembling the wheels put the cart down safely.

13) Check the front wheels for correct position, if

necessary please correct the toe-in. Details are given

in "correct the front wheel part".