Repair; Lifting The Vehicle - Crown C48-2+2 Owner's Manual And Service Manual

OPERATION AND SERVICE INFORMATION
cause severe injury to operator or bystander, damage to seals, plastics, seat material, body finish or electrical
system. Do not use pressure in excess of 700 psi to wash exterior of vehicle.
Clean windshield with lots of water and a clean cloth. Minor scratches may be removed using a commercial
plastic polish.
Normal cleaning of vinyl seats and plastic or rubber trim requires the use of a mild soap solution applied with
a sponge or soft brush and wipe with a damp cloth.
The painted surfaces of the vehicle provide attractive appearance and durable protection. Frequent washing
with lukewarm or cold water and mild detergent is required to preserve the painted surface.
Occasional cleaning and waxing with non-abrasive products designed for 'clear coat' automotive finishes will
enhance the appearance and durability of the painted surfaces.
Corrosive materials used as fertilizers or for dust control can collect on the underbody of the vehicle. These
materials will cause corrosion of underbody parts unless flushed occasionally with plain water. Thoroughly
clean any areas where mud or other debris can collect. Sediment packed in closed areas should be loosened to
ease it's removal, taking care not to chip or otherwise damage paint.

REPAIR

LIFTING THE VEHICLE

Tool List Qty. Required
Floor jack ..................... 1
Jack stands .................. 4
Chocks ..................... 4
Some servicing operations may require the front wheels, the rear wheels, or the entire vehicle be raised.
! WARNING !
To reduce the possibility of severe injury or death from a vehicle falling from a jack:
Be sure the vehicle is on a firm and level surface.
Never get under a vehicle while it is supported by a jack.
Use jack stands and test the stability of the vehicle on the stands.
Always place chocks in front and behind the wheels not being raised.
Use extreme care since the vehicle is extremely unstable during the lifting process.
! CAUTION !
When lifting vehicle, position jacks and jack stands at the areas indicated only.
To raise the entire vehicle, install chocks in front and behind each front wheel. Center the jack under the rear
frame crossmember. Raise the vehicle enough to place a jack stand under the outer ends of the rear axle.
Lower the jack and test the stability of the vehicle on the two jack stands.
Place the jack at the center of the front axle. Raise the vehicle enough to place jack stands under the frame
crossmember as indicated.
15
Owner's Manual and Service Guide