Charging, Cleaning - Crown C48-2+2 Owner's Manual And Service Manual

OPERATION AND SERVICE INFORMATION
of the plates.
2. If there is no electrolyte visible, add just enough distilled/deionized water to cover the plates.
3.Replace and tighten all water vent caps.
4. Put batteries on a complete charge before adding any additional water (refer to the Charging section).
5. Once charging is completed, remove the vent caps and check the electrolyte level.
6. Add water until the electrolyte level is 1/8" below the bottom of the fill well.
7. Clean, replace, and tighten all vent caps.
!WARNING !
Never add acid to a battery.
CHARGING
Charging batteries properly requires administering the right amount of current at the right voltage. Most
charging equipment automatically regulates these values. Some chargers allow the user to set these values.
For proper charging, refer to the instructions that came with your charging equipment.
Important things to remember:
1. Become familiar with and follow the instructions issued by the charger manufacturer.
2. Batteries should be charged after each period of use.
3. Lead acid batteries do not develop a memory and need not be fully discharged before recharging.
4. Charge only in well-ventilated area. Keep sparks or flames away from a charging battery.
5. Verify charger voltage settings are correct .
6. Check electrolyte level.(See Watering section).
7. Tighten all vent caps before charging.
8. Do not overcharging or undercharging the batteries.
9. Do not charge a frozen battery.
10. Avoid charging at temperatures above 48℃.
How To Increase System Power
Two or more batteries can be easily connected to boost your system's voltage and/or capacity. There are three
methods to obtain additional voltage and/or capacity, as described below:
To increase voltage, connect batteries in series.
-
+
-
+
Battery System:12 Volt,226 AH Using Two DT106 Deep
Cycle Batteries(6 Volts,226AH)
To increase amp-hour capacity, connect batteries in parallel.
40
Owner's Manual and Service Guide