Diagnostic Mode Feature, Starting And Driving, Start Vehicle On A Hill - Crown C48-2+2 Owner's Manual And Service Manual

OPERATION AND SERVICE INFORMATION
Walk-Away Feature
Walk-Away limits vehicle movement without driver input, slowing the vehicle to 3kph and sounding an
audible alarm ( reverse beeper).
Example: If all of the following events occur
a) the vehicle has been stopped for more than 1.5 seconds
b) the accelerator pedal has been released for more than one second
c) the vehicle begins to roll above 3kph
the electronic braking will limit speed to approximately 3 kph and the warning beeper will sound. When the
accelerator pedal is depressed, the electronic braking and warning beeper will be overridden and normal
vehicle operation resumes.
Diagnostic Mode Feature
Diagnostic mode eases troubleshooting.
In the unlikely event of certain electrical system failures, the controller will default to a mode that will permit
the vehicle to operate, but at a very reduced speed.
This feature allows the vehicle to be driven back to its storage facility where the problem can be diagnosed.
The controller can be put in diagnostic mode by the technician and the controller will report the failure mode.
STARTING AND DRIVING
! WARNING !
To reduce the possibility of roll-back which could result in severe injury or vehicle
damage, do not release the service brake until motor has started.
All vehicle are equipped with an interlock system that disables the controller and prevents the vehicle from
being operated while the charger is connected. The interlock functions even if the DC plug is not fully
connected in the vehicle receptacle. Remove charger plug from vehicle receptacle and properly store cable
prior to moving vehicle.
To operate vehicle:
·Apply the service brake, place the key in the key switch and turn it to the "ON" position.
·Move the direction selector to the direction desired.
·Release the park brake by depressing the service brake pedal until the park releases.
·Slowly depress the accelerator pedal to start the motor. Release service brake when motor starts.
·When the accelerator pedal is released, the motor stops. To stop the vehicle more quickly, depress the
service brake pedal.
Note:
When the direction selector is in the reverse position, a warning signal will sound to indicates that the
vehicle is ready to run in reverse.
13
Owner's Manual and Service Guide