Maintenance; Replacement Parts - Porter-Cable PCE211 Instruction Manual

• Bolt Size: Larger bolt diameters
generally require higher fastening torque.
Fastening torque will also vary according
to length, grade, and torque coefficient.
• Bolt: Ensure that all threads are free of
rust and other debris to allow proper
fastening torque
• Material: The type of material and
surface finish of the material will affect
fastening torque.
• Fastening Time: Longer fastening
time results in increased fastening
torque. Using a longer fastening time
than recommended could cause the
fasteners to be overstressed, stripped or
damaged.
Capacity
Your 1/2" (12.7 mm) impact wrench uses
sockets with 1/2" (12.7 mm) square drive ends.

Maintenance

WARNING:
To reduce the risk of
Injury, turn unit off and disconnect it
from power source before installing
and removing accessories, before
adjusting or when making repairs. An
accidental start-up can cause injury.
Cleaning
WARNING:
Blow dirt and dust out of
all air vents with clean, dry air at least
once a week. To minimize the risk of eye
injury, always wear ANSI Z87.1 approved
eye protection when performing this.
WARNING:
Never use solvents or
other harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals
may weaken the plastic materials used in
these parts. Use a cloth dampened only
with water and mild soap. Never let any
liquid get inside the tool; never immerse
any part of the tool into a liquid.

Replacement Parts

Use only identical replacement parts.
For a parts list or to order parts, visit our
service website at www.portercable.com.
You can also order parts from your nearest
PORTER-CABLE Factory Service Center
or PORTER-CABLE Authorized Warranty
Service Center. Or, you can call our
Customer Care Center at (888) 848-5175.
This Class B digital apparatus complies
with Canadian ICES-003.
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
NOTE: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an
experienced radio/TV technician for
help.
Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
This Class B digital apparatus complies
with Canadian ICES-003.
6