Automatic Buttonhole - Janome Sewist 725s Instruction Book

q w
r
t
z
q
x
(A)
e
r
e
w
(B)

Automatic Buttonhole

q Stitch pattern:
w Stitch width:
e Stitch length:
r Thread tension: 1 – 5
t Presser foot:
NOTE:
The size of buttonhole is automatically
determined by placing the button in the
automatic buttonhole foot.
The button holder of the foot takes a button
size up to 1˝ (2.5 cm) in diameter.
Make a test buttonhole on a sample
duplicating the fabric, interfacing and seams
of the actual garment to check the settings.
Use interfacing on stretch fabrics.
Turn the handwheel toward you to raise the
needle to its highest position.
z Place the automatic buttonhole foot with the
pin lies just under the groove on the foot
holder. Lower the foot lifter to snap the foot in
place.
q Groove
w Pin
x Pull to open the button holder to the back
(A), and place the button in it. Push back (B)
the button holder against the button to hold it
tight.
e Button holder
NOTE:
For thick buttons, make a test buttonhole.
If the button does not fit through the test
buttonhole, lengthen the buttonhole by
pulling the button holder a little to the back.
r Pull a little
25
BH
4 – 5
0.5 – 1
Automatic buttonhole foot R