Using The Network Settings - Sony SNC-HMX70 Application Manual

IPv6 Setting tab (when multiple devices are
selected from a device list)
You can configure network information (IPv6) for
multiple devices selected from the Device list.
Based on the multiple devices selected, the following
points are different from the Basic Setting tab when a
single device is selected.
Use the following IP address: Sets the DHCP mode off,
then specifying the start and end IP addresses
enables you to configure sequential IP addresses.
Network address: Displayed when multiple devices are
selected from a device list and when multiple
network addresses exist. Selecting the network
address where the device you want to configure
exists enables you to configure collectively.

Using the Network settings

1
Select a device you want to assign an IP address to
from the list and click Network.
The account settings screen is displayed.
2
Register the name and password of the
administrator and click OK.
8
Using the SNC toolbox
For the Administrator name and Administrator
password set at factory settings, please refer to the
User's Guide of each model.
The Network Setting screen is displayed.
3
Set the IP address.
To obtain the IP address automatically from a
DHCP server:
Select Obtain IP address automatically.
The IP address, Subnet mask and Default gateway
are assigned automatically.
Note
When you select Obtain IP address
automatically, make sure that the DHCP server is
operating on the network.
To specify the IP address manually:
Select Use the following IP address, and type the
IP address, Subnet mask and Default gateway in the
relevant boxes.
4
Set the DNS server address.
To obtain the DNS server addresses
automatically:
Select Obtain DNS server address automatically.
To specify the DNS server addresses manually:
Select Use the following DNS server address, and
type the Primary DNS server address and
Secondary DNS server address in the relevant
boxes.
5
Set the HTTP port No.
Normally, select 80 for the HTTP port No. To use
another port number, type a port number between
1024 and 65535 in the text box.