Sony SNC-HMX70 Application Manual page 7

HTTP port No.: Normally, 80 should be selected.
When setting a value other than 80, select the textbox
and enter a port number.
Basic Setting tab (when multiple devices are
selected from the device list)
You can configure network information (IPv4) for
multiple devices selected in the device list.
Based on the selected multiple devices, the following
points are different from the Basic Setting tab when a
single device is selected.
Use the following IP address: Sets the DHCP mode off,
then specifying the start and end IP addresses
enables you to configure sequential IP addresses.
Network address: Displayed when multiple devices are
selected from the device list and multiple network
addresses exist. Selecting the network address where
the device you want to configure exists enables you
to configure collectively.
IPv6 Setting tab (when a single device is
selected from the device list)
You can configure the network information (IPv6) of a
single device selected in the device list.
Device list: Displays devices for IPv6. After selecting
and setting a device to configure, the device list will
be updated automatically.
IPv6: Enables you to switch IPv6 modes.
Obtain IP address automatically: Sets DHCP mode to
on.
Use the following IP address: Sets DHCP mode to off.
When this is set, specify an IP address, prefix, default
gateway to specify the fixed address. You can also
add a check to "After getting response of ping, the IP
will be skipped" to determine whether the specified
IP address is already in use or not.
Obtain DNS server address automatically: Sets DNS
mode to on.
Use the following DNS server address: Sets DNS
mode to off. When this is set, specify a preference
DNS server address and alternative DNS server
address.
7
Using the SNC toolbox