Reset the mounting screws
It is important to reset the mounting screws to ensure
correct remounting of the camera.
1
Using the T10 Allen key, turn each mounting screw
four full turns clockwise to tighten them (this resets
the mounting clips).
2
Close the flaps.
4
T10
4
T10
8
Network connection
Network (and PoE power)
Connect the camera to a 10/100 Base-T network:
– Use STP Category 5e cable with RJ45 connectors (the
camera network socket is Auto MDIX compliant).
– Power is supplied to the camera via the Ethernet cable
compliant with the Power-over-Ethernet standard.
Caution
Use only PoE approved devices.