Standalone Mode; Standalone Mode Setup; Connection - Honeywell Ultrakey Lite User Manual

Standalone Mode

7 Standalone Mode

Standalone Mode Setup

Connection

28
This chapter describes connection and configuration instructions of UltraKey Lite in
Standalone mode.
The Standalone Mode is used to control DVR and PTZ.
Refer to "Mode Selection" on page
Figure 7-1 Standalone main menu
To connect PTZ with Ultrakey Lite, refer to the following figures:
Figure 7-2 Connecting PTZ by DVR Control
10 to set the mode as STANDALONE.
RJ45 to DB9F,
for RS232
Network
cable
Serial Port(RS232)
Ultrakey Lite