Siemens SIMATIC S7-1500 Automation System System Manual page 75

Bringing the front connector directly into final position
Proceed as follows to bring the front connector directly into final position:
1. Grip the front connector by the unlocking strap.
2. Push the guide pin of the front connector into the guide channel that has been displaced
3. Tilt the front connector and press it into the I/O module until it latches. The front
4. Swivel the front cover down into place. Depending on the space requirement of the cable
S7-1500 Automation System
System Manual, 01/2013, A5E03461182-01
downwards. The front connector slides over the guide channel into its final position.
Figure 6-16 Bringing the front connector directly into final position
connector is now electrically connected with the I/O module.
harness, various latch positions are possible, so that the required cable storage space
can grow as needed.
6.8 Front connector for the I/O modules
Wiring
75