OHAUS TD52 Instruction Manual page 10

EN-8
4. Install the Li battery packing. Push it along the arrow. (Note: slot 2 match with the rib of
the red part).
5. Secure it with one screw (Note: Boss Post is 10). Connect the cable to Li battery
packing 7 pin connectors.
6. Put the rear housing back on the front housing. Re-install the 6 screws. Fasten the 6
screws with sealed washer (Torque is 1.8N*m± 0.5).
Slot 2
Boss post 10
7 Pin connector
screw
Rib