Locating A Scene On A Tape For Playback ( Trv265E); Searching Quickly For A Desired Scene - Zero Set Memory - Sony Handycam CCD-TRV228E Operation Manual

* Pictures can be reproduced more faithfully by using
an S video cable (optional). When there is an S video
jack on the device to be connected, connecting the S
video cable (optional) to the S video jacks on both
your camcorder and the device instead of using the
yellow plug is recommended.
The audio will not be output when you connect with
the S video plug alone.
When your TV is connected to a VCR
Connect your camcorder to the LINE IN input
on the VCR using the A/V connecting cable. Set
the input selector on the VCR to LINE.
To connect to a TV without audio/video
input jacks
For TRV228E/428E:
Use a PAL system RFU adaptor (optional).
Refer to the operating instructions of your TV
and the RFU adaptor.
When your TV is stereo
For TRV228E/428E:
Connect the audio plug of the A/V connecting
cable to the left (white) input jack of your TV.
When your TV is monaural (When your
TV has only one audio input jack)
For TRV255E/265E:
Connect the yellow plug of the A/V connecting
cable to the video input jack and connect the
white or the red plug to the audio input jack of
your TV or VCR.
When you want to play the sound in monaural
mode, use a connecting cable (optional) for that
purpose.
If your TV/VCR has a 21-pin connector
(EUROCONNECTOR)
Use the 21-pin adaptor supplied with your
camcorder (For models with the
printed on their bottom surfaces only). This
adaptor is designed for output use only.
For TRV228E/428E:
For TRV255E/265E:
40
Playback
Locating a scene on a
tape for playback
( TRV265E)
Searching quickly for a desired
scene – Zero set memory
1
During playback, press ZERO SET
MEMORY on the Remote
Commander at the point you want to
locate later on.
The tape counter is reset to "0:00:00" and
If the tape counter is not displayed, press
DISPLAY on the Remote Commander.
2
Press STOP when you want to stop
playback.
3
Press m REW.
The tape stops automatically when the tape
mark
counter reaches "0:00:00."
4
Press PLAY.
The playback starts from the point
designated "0:00:00" on the tape counter.
TV/VCR
To cancel the operation
Press ZERO SET MEMORY on the Remote
Commander again.
TV/VCR
m REW
PLAY
STOP
DISPLAY
ZERO SET MEMORY
appears on the screen.