Step 2: Charging The Battery Pack - Sony Handycam CCD-TRV228E Operation Manual

Step 2: Charging the
battery pack
You can charge the battery by attaching the
"InfoLITHIUM" battery pack (M series)
to your camcorder.
b Notes
• You cannot use batteries other than the
"InfoLITHIUM" battery pack (M series) (p. 82).
• Do not short-circuit the DC plug of the AC Adaptor
or battery terminals with any metallic objects. This
may cause a malfunction.
• Use a nearby wall socket when using the AC
Adaptor. Disconnect the AC Adaptor from the wall
socket immediately if any malfunction occurs.
DC IN jack
Mains lead
To the wall socket
1
Lift up the viewfinder.
12
Getting started
Battery pack
DC plug
AC Adaptor
2
Attach the battery pack by sliding it in
the direction of the arrow until it
clicks.
3
With the v mark on the DC plug
facing up, connect the AC Adaptor to
the DC IN jack on your camcorder.
v mark
4
Connect the mains lead to the AC
Adaptor.
5
Connect the mains lead to the wall
socket.
6
Slide the POWER switch up to (CHG)
OFF.
The CHG (charge) lamp lights up and
charging starts.