Components and parts containing toner and ink,
including liquids, semi-liquids (gel/paste) and toner
Components and waste containing asbestos
Components, parts and materials containing
refractory ceramic fibers
Components, parts and materials containing
radioactive substances
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Screw driver
Disassembly Tool
Bolt sleeve
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1.
Lay the display on desk, separate Stand from display Head.
2. Unscrew Back Cover, unhook Bucket from Bezel.
3. Remove the accessories(Tape, Al Foil, etc), disconnect some terminals.
4.
Take out Chassis and Panel.
5.
Unscrew Power and IF board, take them out and disconnect the terminals
6.
Peel off mylars from Chassis
7.
8.
9.
10.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00
Template Revision B
Include the cartridges, print heads, tubes, vent
chambers, and service stations.
PSG instructions for this template are available at
EL-MF877-01
0
0
0
0
Tool Size (if
applicable)
Ph2/Ph00
Page 2