Fitting The Burner Heat Shield; Arrangement Of The Fuel Effect - Nu-Flame Vitesse H.E. Use, Installation & Servicing Instructions

16. - FITTING THE BURNER HEAT SHIELD

There are two shapes of burner heat shield and the type you will need is determined by whether you have a Flat Trim or a Curved
Trim. For this reason the appropriate Burner Heat Shield is packed with the Trim. The 2 # No8 x 10mm blunt self tapping screws to
fit the trim are in with the fitting kit included with the Main Convector.
Screw the Burner Heat Shield onto the top of the burner mounting plate using the 2 # No8 x 10mm blunt self tapping screws; there is
one hole on each side. When fitted the Burner Heat Shield slopes away from the burner. It cannot be fitted the wrong way round as
it will foul on the burner.
You will have already fixed the burners into the Convector Box, but for clarity the photos below show the burners unfitted.
Burner with Burner Heat Shield for
Flat Trim Fitted
! IMPORTANT NOTE !
17. - ARRANGEMENT OF THE FUEL EFFECT (COALS or PEBBLES).
For fire models with a Curved Trim additional Fuel Bed Components are provided.
Remove all the Fuel Effect parts and Familiarise Yourself with Each Part. You will see that the Cluster Coals and Peb-
bles are Numbered 1 to 5.
The Curved Loose Coals and Pebbles are Lettered A to F.
! TIP !
Take care not to damage liner panels.
a. Fit the Matrix
b. Fit No5 Centre Cluster Coal/Pebble
Note pegs on the matrix locate into
Holes in Base.
Failure to fit the appropriate Burner Heat Shield will invalidate the guarantee.
Burner with Burner Heat Shield for
20
Curved Trim Fitted