Lcdi Power Cord & Plug - PA 1PPEC8000 User Manual

LCDI POWER CORD & PLUG
This air conditioner is equipped with an LCDI (Leakage Current Detection and Interruption) power
cord and plug as required by US National Electric Code 440.65. This cord consists of a length of
shielded flexible cord with no termination on the load side and a LCDI attachment plug on the
line side.
The LCDI power cord and plug will remove the supply source via electrical disconnect (circuit
trip) if the nominal current leakage between the cord shield and either load conductor exceeds a
predetermined value. The cord will remain de-energized until the device has been manually reset. This
is intended to reduce the risk of a fire in the power cord or combustible materials nearby. The cord
shields are not grounded and they must be considered shock hazards if exposed. The cord shield
must not be connected to the ground or to any exposed metal.
The test and reset buttons on the LCDI Plug are used to check if the plug is functioning properly. To
test, follow the steps below that correspond to the plug on your unit:
LCDI POWER CORD & PLUG
1. Plug power cord into wall outlet.
2. Press TEST Button, circuit should trip,
cutting power to the air conditioner.
3. Press RESET button for use.
NOTE Your unit's power cord may differ from the one shown.
If test button is pressed and unit can still be turned on, current leakage has been detected. Do not
use the air conditioner or attempt to reset the LCDI Plug. Contact Perfect Aire Consumer Services at
844-472-2473 for troubleshooting recommendations.
WARNING
1. DO NOT press the TEST button while the air conditioner is operating.
2. The TEST and RESET buttons should not be used as "ON" and "OFF" switches.
3. The cord and plug are not intended to offer protection to externally connected loads or
supply circuits.
4. The cord and plug are intended for indoor use only.
2
RESET
TEST
ALTERNATE PLUG WITH LED LIGHT
1. Plug power cord into wall outlet. The LED
light will turn on.
2. Press TEST Button, circuit should trip,
cutting power to the air conditioner. When
this occurs, the LED light will turn off.
3. Press RESET button for use. Once power
is restored, the LED light will turn on again.
LED
LIGHT