Stamina 7000 EMR Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 5:
Pull the ends of the
FRAME(1).
Slide the
CONNECTION WIRE(31)
TENSION CABLE(28)
SENSOR WIRE(32).
CABLE(28)
is accessible through the square hole in the
MAIN FRAME(1)
with
UPRIGHT SLEEVE(37)
Slide the
NOTE: The square hole in the
STEP 6:
Pull the end of the
TENSION KNOB(29)
the
SPRING HOOK
the
so that enough cable is available to insert the cable through the slot in the
METAL FITTING
on the
STEP 7:
Install the
SCREW(M5 x 45mm)(67)
TENSION CABLE(28)
UPRIGHT SLEEVE(37)
UPRIGHT(4)
into the
into the bottom end of the
UPRIGHT(4)
Insert the
BUTTON HEAD BOLTS(M8 x 15mm)(50)
down to cover the bolts on the
UPRIGHT(4)
TENSION CABLE(28)
"1".
at position
TENSION CABLE(28).
on the end of the
TENSION KNOB(29)
TENSION KNOB(29)
ARC WASHER(M5)(68).
and
METAL FITTING
CABLE END
BRACKET
SPRING HOOK
SENSOR WIRE(32)
and
UPRIGHT(4).
onto the
and connect it to the
UPRIGHT(4). NOTE:
MAIN FRAME(1).
onto the
UPRIGHT(4).
is on the side facing the user as shown.
through the square hole in the
CABLE END
Connect the
into the hole at the end of the slot in the
into the square hole on the
8
Insert the female end of the
SENSOR WIRE(32).
Be careful not to damage the
Make sure that the
UPRIGHT(4)
Secure the
ARC WASHERS(M8)(62).
and
UPRIGHT(4).
TENSION KNOB(29)
of the
TENSION KNOB(29)
Pull on the
BRACKET.
UPRIGHT(4)
MAIN
out of the
Slide the
TENSION
to the
UPRIGHT(4).
Set
into
firmly
Then insert the
BRACKET.
and secure with