Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
STEP 3:
Attach the
WASHERS(M8)(69).
SEAT POST(6)
insert the
NOTE:
It may be necessary to unscrew the
1.
Make sure that the pin on the
2.
SEAT POST(6).
SPRING PIN KNOB(44)
3.
The
securely in the
STEP 4
RIGHT PEDAL(40)
NOTE:
The
has right hand threads and is tightened by turning clockwise. The
on the end of the pedal shaft. The
turning counter clockwise.
RIGHT PEDAL(40)
Thread the
the pedal securely. Select the
strap. Snap the three hole end onto the inside edge of the
the outside edge of the
STRAP(41).
Select adjustment holes which allow your foot to be easily removed from the pedals.
Use the same procedure to attach the
LEFT PEDAL STRAP(39)
SEAT(45)
onto the
SPRING PIN KNOB(44)
Pull out the
MAIN FRAME(1)
into the
SPRING PIN KNOB(44)
MAIN FRAME(1).
R
has
stamped on the end of the pedal shaft. The
onto the right side of the
RIGHT PEDAL STRAP(41)
RIGHT PEDAL(40)
LEFT PEDAL(38)
LEFT PEDAL(38).
onto the
SEAT POST(6)
with
and secure with the
SPRING PIN KNOB(44)
should be screwed in tight to make the
LEFT PEDAL(38)
CRANK(7)
which has
RIGHT PEDAL(40).
R
with the
mark on the bottom of the
onto the left side of the
7
NYLOCK NUTS(M8)(70)
MAIN FRAME(1).
located on the
SPRING PIN KNOB(44).
slightly to insert the
is inserted into one of the holes in the
RIGHT PEDAL(40)
LEFT PEDAL(38)
has left hand threads and is tightened by
as shown. Use a wrench to tighten
R
marked on the bottom side of the
Snap the other end onto
CRANK(7)
LOCK
and
Then
SEAT POST(6).
SEAT POST(6)
fit
L
has
stamped
RIGHT PEDAL
and snap the
Advertisement
Table of Contents
