Set T2 Mode (Second Time Zone); Set Dive Mode - Seac DRIVER User Manual

SET T2 MODE (SECOND TIME ZONE)

• To enter SET "T2", set T2 as the primary display, and then press and hold the
"M" button from the T2 screen.
• The minutes digits flash: increase the value with the "U" button or decrease
with the "D" . Briefly press the "M" button to confirm.
• The hours digits flash: increase the value with the "U" button or decrease
with the "D" . Briefly press the "M" button to confirm.
• Confirm and exit SET "T2" by pressing the "M" button.

SET DIVE MODE

Sampling Rate (/ sec)
Default: 2 seconds
Set MAX DEPTH
Default: 50m
Range: 3 - 120 m
To enter SET "DIVE", press and hold the "M" button from the DIVE screen.
T2 TIME SETTING mode
Set T2 Hour
Default time: 12:00:00
DIVE SETTING mode
Default: SEA
Enable/Disable MAX
DEPTH Alert
Default: off
Set T2 Minute
Minimum Suggested
Surface Time Alert
Default: off
Set MAX DIVE TIME
mm:ss
Default: 10:00
increment per 10s
Range: 00:10 ~ 99:50
DRIVER
Enable/Disable MAX
DIVE TIME Alert
Default: off
9