SAP-200 indications
Depending on the measurement one of the
below symbols will lit and the process
value displayed (see P01 chapter 6.1).
Engineering units will be indicated directly
(°C, °F and mA) and by the lit arrow
showing towards them on the frame
• DIST
distance
• LEV
level
• VOL
volume
• FLOW flow
• T1/T2
totalised values
• FAIL
(blinking) Error code displayed
For paging readouts NEXT
be pressed.
5.2.4 QUICKSET
Recommended as a simple and fast way to start up EchoTREK.
QUICKSET programming (aided by 6 screens) is used in uncomplicated level metering
applications to set the 6 basic parameters. The other parameters can only be modified in the Full
Parameter Access Mode see 5.1 (P01).
The instructions of this programming mode are also to be found on the front panel above the
Display Module socket.
SE/SG-300 series two-wire compact ultrasonic level transmitters
The following process values can be displayed
• Volume / Flow – if programmed so
• Level – if programmed so
• Distance – if programmed so
• Warning indications – FAIL blinking
Display screens can be scrolled by pressing key NEXT
To return to the screen of the selected measurement mode
key ENTER
E
Temperature can be displayed by pressing UP
key should
Current output value can be displayed
by pressing DOWN
should be pressed (see P01 chapter 6.1)
(°C/°F)
.
(mA)
(Vol/Flow)
.
See P01
for possible readouts
.
(Distance)
(Error)
17