Programming With The Sap-200 Display Module - Echotrek SG-300 Series Installation And Programming Manual

5.2 Programming with the SAP-200 Display Module

The EchoTREK should be adjusted to the process by programming the parameters. The SAP-200 Display Module can be used to display the parameters during
programming and measurement values during measurement.
The SAP-200 supports two separately accessible programming modes representing 2-layers of programming complexity, depending on user choice.
QUICKSET (5.2.4)
Recommended as a simple and fast way to set up the EchoTREK by 6 basic parameters
for the following basic settings, marked by abbreviationseasy to remember
• Engineering unit for the display (Metric or US)
• Maximum measuring distance (H)
• Assignment of min level to 4 mA
• Assignment of max level to 20 mA
• Error indication by the current output
• Damping time
Full Parameter Access (5.2.5)
All features of the EchoTREK such as:
• Measurement configuration
• Outputs
• Measurement optimalisation
• 11 pre-programmed tank shapes for volume calculation
• 21 pre-programmed formula for flow metering
• 32-point linearisation
14
PLUG-IN DISPLAY MODULE
QUICKSET
FULL
PARAMETER
ACCESS
SE/SG-300 series two-wire compact ultrasonic level transmitters