Table of Contents
Advertisement
Double key pressing
Press the two keys simultaneously for desired programming step.
Enter into or quit programming modes
E
GET LEVEL function
Special function used only in level and distance measurement modes
Notes:
If after pressing ENTER
blinking does not spring over from the parameter address to the parameter value this means that
E
•
the parameter is either a read-out type, or
•
the secret code prevents the modification (see P99)
If the modification of the parameter value is not accepted i.e. the parameter value keeps blinking after pressing ENTER
•
the modified value is either out of the range, or
•
the code entered is not a valid code
5.2.3 Indications of the SAP-200 and LED Status
16
Basic steps while parameter address is blinking
E
Return to default*
* LOAD readout ** CANCEL readout
+ DOWN
UP
4...20mA
Basic steps while parameter value is blinking
E
Display default value
* cancellation immediately active
,
E
LED indication
•
ECHO-LED
lit in case of
valid echo.
•
COM-LED
see description of HART
SE/SG-300 series two-wire compact ultrasonic level transmitters
Advertisement
Table of Contents
