Safe Operation; Daily Safety Checks - Triumph Daytrona 675 Manual

General Information

Safe Operation

Daily Safety Checks

Check the following items each day before
you ride. The time required is minimal, and
these checks will help ensure a safe, reliable
ride.
If any irregularities are found during these
checks, refer to the Maintenance and
Adjustment section or see your authorized
Triumph dealer for the action required to
return the motorcycle to a safe operating
condition.
Warning
Failure to perform these checks every day
before you ride may result in serious
motorcycle damage or an accident causing
serious injury or death.
Check:
Fuel: Adequate supply in tank, no fuel leaks
(page 45).
Engine Oil: Correct level on dipstick. Add
correct specification oil as required. No leaks
from the engine or oil cooler (page 74).
Drive Chain: Correct adjustment (page 84).
Tires/Wheels: Correct inflation pressures
(when cold). Tread depth/wear, tire/wheel
damage, punctures etc. (page 105).
Nuts, Bolts, Fasteners: Visually check that
steering and suspension components, axles,
and all controls are properly tightened or
52
fastened. Inspect all areas for loose/damaged
fasteners.
Steering Action: Smooth but not loose from
lock to lock. No binding of any of the control
cables (page 93).
Brakes: Pull the brake lever and push the
brake pedal to check for correct resistance.
Investigate any lever/pedal where the travel is
excessive before meeting resistance, or if
either control feels spongy in operation
(page 88).
Brake Pads: There should be more than
0.06 in (1.5 mm)
remaining on all the pads (page 88).
Brake Fluid Levels: No brake fluid leakage.
Brake fluid levels must be between the MAX
and MIN marks on both reservoirs (page 88).
Front Forks: Smooth action. No leaks from
fork seals (page 95).
Throttle: Throttle grip free play 0.8 - 0. 1 2 in
(2 - 3 mm). Ensure that the throttle grip
returns to the idle position without sticking
(page 81).
Clutch: Smooth operation and correct cable
free play (page 83).
Coolant: No coolant leakage. Check the
coolant level in the expansion tank (when the
engine is cold) (page 77).
Electrical Equipment: All lights and the
horn function correctly (page 40).
Engine Stop: Stop switch turns the engine
off (page 54).
Stands: Returns to the fully up position by
spring tension. Return springs not weak or
damaged (page 48).
of friction material