Developer Board Safety; Contact Us - Motorola G24 Developer's Manual

Developer Board Safety

Developer Board Safety
Precautions
Most Developer Board circuits are not shielded. Be sure to take appropriate precautionary
measures in order to avoid ESD while handling the kit. ESD can damage the Developer Board
and/or the G24 module attached to it.
User Operation
Do not operate your unit when a person is within eight inches (20 centimeters) of the antenna. A
person or object within eight inches (20 centimeters) of the antenna could impair call quality and
may cause the unit to operate at a higher power level than necessary, as well as expose that person
to RF energy in excess of that established by the FCC RF Exposure Guidelines.
Important:
Important:
Antenna Installation
•
A minimum separation distance of eight inches (20 centimeters) must be maintained between
the antenna and all persons.
•
The effective radiated power of the transmitter must be less than 3.0 Watts ERP (4.9 Watts or
36.9 dBm EIRP). This requires that the combination of antenna gain and feed line loss
should not exceed 16 dBi.

Contact Us

We at Motorola want to make this guide as helpful as possible. Keep us informed of your
comments and suggestions for improvements.
For general contact, technical support, report documentation errors and to order manuals, use this
email address:
n2cshd@motorola.com
Motorola appreciates feedback from the users of our information.
viii
The unit must be installed in a manner that provides a minimum separation distance
of eight inches (20 centimeters) or more between the antenna and persons and must
not be co-located or operate in conjunction with any other antenna or transmitter in
order to satisfy FCC RF exposure requirements for mobile transmitting devices.
To comply with the FCC RF exposure limits and to satisfy the categorical exclusion
requirements for mobile transmitters, the requirements described in the following
section, "Antenna Installation"
Developer's Kit
, must be met.
April 1, 2006