Power Up - Motorola G24 Developer's Manual

Power Up

Important:
To Turn on the Power
1. Turn on the Developer Board power by switching the power On/Off switch (S200) to ON
(Figure 2-3, on page
The Developer Board power On/Off switch (labeled Power ) is located at the rear of the
Developer Board.
The Developer Board power indicator LED is lit.
2. Turn on the G24 power by pressing the On/Off pushbutton (S110) for at least 0.5 seconds
(Figure
The G24 power On/Off pushbutton is located at the front of the Developer Board.
The G24 On/Off LED is lit.
Figure 2-6: G24 On/Off Pushbutton and Power Indicator LED
Initial Setup of the Developer Board is now complete and the board is ready for use.
April 1, 2006
Chapter 2: Developer Board and Interfaces Description
You must turn the Developer Board power on before turning on the G24.
9).
2-6).
SIM Tray
Developer's Kit
G24 Power
Indicator
G24 On/Off
Pushbutton
11