Datum Point (Part Zero) To Work With Tool Compensation - Fagor Innova 30i-E Installation And Operation Manual

2.4.3

Datum point (part zero) to work with tool compensation

Set the dro in absolute mode.
ABS
Move the tool and touch the side of th e part, activate the corresponding
compensation and set the axis to zero.
Y
X
In the example of the figure, the sequence would be:
For the X axis, move the tool and touch it on the left side and press this key.
To preset this side to "0". See note.
For the Y axis, move the tool and touch it on the lower side and press this key.
To preset this side to "0". See note.
Notes:
If installation parameter PAR11=1, just press the axis key, [X] [Y] or [Z], to zero it.
The tool diameter value must be previous entered in order to set the da tum (zero)
point correctly.
30iE - v1111 - Installation/Operation - (12/48)