General Technical Characteristics - Fagor Innova 30i-E Installation And Operation Manual

UL seal
In order to comply with UL stand ards, this unit must be connected in the fin al application using a listed
UL
detachable cord set (BLEZ) with a molded three-prong plug and a suitable fitting to be connected to the
seal
equipment, rated minimum 300 V AC. The cord type shall be SO, SJO or STO. Suitable Strain Relief
means must be provided in the cord set to assure the connection of the plug and the fitting.
ETL file number:
CE seal (see "CE seal" on page 43)
WARNING

3.3 General technical characteristics

• Universal Power Supply between 100V AC and 240V AC ±10% at Mains frequency
• It withstands power outages of up to 20 milliseconds.
• 10-year memory backup of installation parameters when the unit is off.
• The operating temperature inside th e DRO e nclosure must be between 5º C and
• The storage temperature inside the DRO enclosure must be -25 º C and +70º C (-
• Maximum relative humidity: 95% non condensing at 45ºC (113ºF).
• Front Panel Sealing: IP54 (DIN 4005 0), Rear panel: IP4X (DIN40050) except for
Before handling the connectors (mains, feedback, etc.) make sure that the unit is
not under power.
It is NOT enough to turn the display off by using the [on/off] key at the keyboard
between 45 Hz and 400 Hz. Between 120Vdc and 300 Vdc
45º C (41ºF and 113ºF).
13º F and 158º F).
built-in models in which case is: IP20.
30iE - v1111 - Installation/Operation - (28/48)