Table of Contents
Advertisement
2.4 Operating with tools
It is possible to de
machining.
2.4.1 Entering tool dimensions
The Y axis blinks waiting for the tool value to be entered.
20i-M.- It requests the tool diameter.
30i-M.- It requests the diameter on the Y axis and the length on the Z axis.
Enter this value pressing this keystroke sequence.
[Value]
Note:
Since only the diameter of a tool may be stored, when changing a tool, its dimensions
must be entered again.
2.4.2 Tool dimension compensation while machining
To properly machine the part, the tool diameter must be compensated depending on
the machining direction.
Tool
This led turns on when activating any of the compensations.
Cancels tool compensation and turns the Tool led off.
fine a tool a nd later compensate for its dimensions wh ile
30iE - v1111 - Installation/Operation - (11/48)
Advertisement
Table of Contents
