mori seiki NZ-S1500 Operation Manual page 298

SP
CYCLE
START STOP
DOOR
UNLOCK
PREPARATION BEFORE STARTING MASS PRODUCTION
16) Set the rapid traverse rate override, feedrate
override, and spindle speed override if necessary.
Make sure that you can press the EMERGENCY
NOTE
STOP button or the
immediately if an abnormality occurs.
17) Press the
Proceed machining by observing vibration of the
NOTE
machine, cutting sound, chip discharge condition,
and coolant supply condition.
18) With the manual door type machine, when the
program stops after executing the M01 (optional
stop) command, press the DOOR UNLOCK switch
door.
NOTE
19) Measure and record the dimension of the
workpiece.
20) Repeat steps 17) to 19) until program end command
M30 to measure and record the dimensions.
21) After the completion of program execution, display
the OFFSET/WEAR screen.
22) Move the cursor to X or Z of the tool wear offset
number of the tool to be used, using the cursor
control keys.
23) Enter the difference between the dimension
measured in step 20) and the dimension used in
programming.
(START) switch.
to unlock the front door. Then open the front
1. With the automatic door type machine, when
the program stops after executing the M01
(optional stop) command, open the front
door by pressing the AUTOMATIC DOOR
OPEN switch.
2. The machine does not stop if an M01
command is not entered at the end of the
program. Programs used for continuous
operation may not have the M01 command
to shorten cycle time.
E-25
(STOP) switch