mori seiki NZ-S1500 Operation Manual page 294

CYCLE
START STOP
MEM MDI TAPE
H JOG RPD
DOOR
UNLOCK
PREPARATION BEFORE STARTING MASS PRODUCTION
18) Operate the chuck to clamp a workpiece.
19) Close the front door.
NOTE
20) Check the tool motion on the PROGRAM screen by
pressing the
switches alternately.
Check the interference between the tool and the
workpiece or the chuck.
NOTE
21) Check the clearance between the cutting tool and
the chuck in comparison with the data for "DIST. TO
GO" which is displayed on the screen.
NOTE
22) After the completion of the first axis movement
block, select any of the following modes with the
mode selection switch.
EDIT
ZRN
The spindle stops rotating when any of these modes
is selected.
23) With the manual door type machine, press the
DOOR UNLOCK switch
door. Then open the front door.
NOTE
• Page B-32 (7-3)
• Page C-7 (2-1)
Make sure that you can press the EMERGENCY
STOP button or the
immediately if an abnormality occurs.
(START) and
1. The program stops at each block since the
single block function is valid.
However, press the
the X- or Z-axis starts moving.
2. If the coolant OFF mode is currently valid,
coolant will not be supplied even if an M08
(coolant ON) command in the program is
carried out.
If there is a possibility of interference between the
tool and the chuck, stop no-load running and
correct the program. Then, check the program
again.
(H)
(RPD)
With the automatic door type machine, open the
front door by pressing the AUTOMATIC DOOR
OPEN switch.
E-21
(STOP) switch
(STOP)
(STOP) switch if
(JOG)
(ZRN)
to unlock the front