Replace A Memory Dimm - Lenovo ThinkAgile HX Series Hardware Replacement Manual

1u models
Hide thumbs Also See for ThinkAgile HX Series:
Table of Contents

Advertisement

Replace a memory DIMM

A node might be able to self-correct for certain memory errors, however, failed memory can lead to system
degradation and should be quickly replaced. Indications of a failed DIMM are:
A post error on boot
An error in XCC
An error in the Prism web console
Not all memory is detected. For example, the appliance should have 256 GB per node and the host
only shows 240 GB.
The CRUs for 16 GB or 32 GB memory DIMMs are as follows:
Table 6. Memory DIMM options
ThinkSystem 8GB TruDDR4 2666 MHz (1Rx8 1.2V) RDIMM
ThinkSystem 16GB TruDDR4 2666 MHz (2Rx8 1.2V) RDIMM
ThinkSystem 32GB TruDDR4 2666 MHz (2Rx4 1.2V) RDIMM
ThinkSystem 64GB TruDDR4 2666 MHz (4Rx4 1.2V) LRDIMM
Replace a memory DIMM:
1. Identify the failed DIMM by either checking the event logs in UEFI setup or use the XCC web console to
browse the post-event log. The event log contains information about the location of the DIMM fault.
2. Shut down the node by following the hypervisor specific
Nutanix
Hardware Replacement
3. Power off the node and if the cable management arm is not in place, disconnect all the. Pull the node
chassis out of the rack.
4. Remove the top cover as described in the
Information
Center.
5. Remove the air baffle as described in
Center.
6. Replace the memory DIMM as described in the
Information
Center.
7. Replace the air baffle as described in the
Center.
8. Replace the top cover as described in the
Information
Center.
9. Push the node chassis back into the rack and reconnect the cables as necessary. Power on the node.
10. Start the node by following the hypervisor specific
Replacement
Documentation.
11. Verify the DIMM memory failure is resolved:
No error in the post event log
No error shown in XCC
No error shown in Prism
11
Lenovo Converged HX Series Hardware Replacement Guide
Node Shutdown
Documentation.
Removing the top cover
Removing the air baffle
DIMM Replacement
Replacing the air baffle
Replacing the top cover
Node Start
procedure described in the
procedure in the
ThinkSystem
procedure in the
ThinkSystem Information
procedure in the
ThinkSystem
procedure in the
ThinkSystem Information
procedure in the
ThinkSystem
procedure described in the Nutanix
© Copyright Lenovo 2017
Hardware

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinkagile hx3320

Table of Contents