Page 1
T H E O R I G I N A L O P E R A T I N G I N S T R U C T I O N S BM1000 Type designation Product description Bus module PROFIBUS, PROFINET, DEVICENET, ETHERNET/IP Catalog no.
Page 2
Reprint, translation and duplication need to be approved in writing by INFICON GmbH.
About this manual Target groups This installation manual is intended for the owner and for technically qualified personnel with experience in leak detection technology and integration of leak detection devices in leak detection systems. In addition, the installation and use of the unit require knowledge of electronic interfaces.
1.3.2 Text markings Marking Meaning Requirement for execution of an action Tool or aid for an action ► Instruction 1, 2, 3, ... Several instructions in a fixed order Result of an action About this manual...
Safety Intended use The bus module is a device interface between e.g. the MSB box of the mass spectrometer module LDS3000 and an external controller. ► Install, operate and service the unit only in compliance with these instructions. ► Comply with the limits of application (see chapter 4.2, page Owner requirements Safety conscious operation...
Shipment, transport, storage Check the scope of Article Quantity delivery Bus module Installation manual ► Please check the scope of delivery of the product for completeness after receipt. Transport Damage due to unsuitable packaging material Transport in unsuitable packaging material can damage the unit. ►...
Description Construction of the bus module Fig. 1 Front view Connection for the cable to the leak detector (LD) Status LED Lights up green when the operating voltage is applied to the bus module. Function The bus module is a device interface between e.g. the MSB box of the mass spectrometer module LDS3000 and an external controller.
Technical data 4.3.1 Mechanical data Dimensions (W x H x D) 107.6 mm x 89.7 mm x 76.6 mm Weight 500 g 4.3.2 Electrical data Supply voltage 24 V DC 4.3.3 Ambient conditions Permissible ambient temperature (during 10 °C ... 45 °C operation) Permissible storage temperature -20 °C ...
The bus module communicates via data cable with the leak detector and is supplied with voltage by the data cable. INFICON data cable 1 Connect bus module (connection LD) via data cable with the leak detector. 2 Connect the bus module with the external controller by means of the built-in fieldbus module.
Remove the bus module from the DIN-TS35 top hat rail Fig. 3 Removing the bus module 1 Use the flat-tip screwdriver to pull out the locking device. 2 Pull the device off of the top hat rail. Installation and removal...
Disposal The unit can be disposed of by the owner or sent to INFICON. The unit is made of materials that can be reused. You should use this option to avoid waste and save the environment. ► For disposal, always comply with local and regional environmental and safety regulations.
Appendix EC Declaration of Incorporation Appendix...
Page 14
INFICON GmbH, Bonner Strasse 498, D-50968 Cologne, Germany UNITED STATES TAIWAN JAPAN KOREA SINGAPORE GERMANY FRANCE UNITED KINGDOM HONG KONG Vi sit o ur we bsi t e fo r con t act i nfo rm ati on an d o t her sal es o ffice s wo rl dw id e. w w w . i n f i c o n . c o m...