Device Messages - ResMed AirStart 10 APAP User Manual

Problem/possible cause
I am getting a dry or blocked nose
Humidity level may be set too low.
I am getting droplets of water on my nose, in the mask and air tubing
Humidity level may be set too high.
My mouth is very dry and uncomfortable
Air may be escaping through your mouth.
Air pressure in my mask seems too high (it feels like I am getting too much air)
Ramp may be turned off.
Air pressure in my mask seems too low (it feels like I am not getting enough air)
Ramp may be in progress.
My screen is black
Backlight on the screen may have turned off. It turns off
automatically after a short period of time.
Power may not be connected.
I have stopped therapy, but the device is still blowing air
Device is cooling down.
My water tub is leaking
Water tub may not be assembled correctly.
Water tub may be damaged or cracked.

Device messages

Device message/possible cause
High leak detected, check your water tub, tub seal or side cover
Water tub may not be inserted properly.
Water tub seal may not be inserted properly.
High leak detected, connect your tubing
Air tubing may not be connected properly.
10
Solution
Adjust the Humidity Level.
Adjust the Humidity Level.
Increase the Humidity Level.
You may need a chin strap to keep your mouth closed or a
full face mask.
Use the Ramp Time option.
Wait for air pressure to build up or turn Ramp Time off.
Press Home or Select to turn it back on.
Connect the power supply and make sure the plug is fully
inserted.
Device blows a small amount of air in order to avoid
condensation in the air tubing. It will stop automatically after
20 minutes.
Check for damage and reassemble the water tub correctly.
Contact your care provider for a replacement.
Solution
Make sure the water tub is correctly inserted.
Open the water tub and make sure that the seal is correctly
inserted.
Make sure the air tubing is firmly connected at both ends.