ResMed Stellar 150 Quick Start Manual

Client version

Hide thumbs Also See for Stellar 150:

Download this manual

Battery

life %

Power

source

indicator

Alarm

signal

light

Alarm

Mute

How to power on/off

When unit is plugged in and screen remains dark, flick the ON/Standby switch at the back of the unit next

to the power cord inlet. The screen will light up and the unit will exhale once. The screen will display the

time and date. To power off, flick switch at back of unit, the screen will prompt the user to answer Yes/No

to power off. Select your response by turning the push dial to highlight Yes or No, then press the dial to

make your choice.

How to Start/ stop

To start the blower press the start/stop button that is lit up below the push dial. The blower will be

initiated. To stop the blower press start/stop and the screen will prompt the user to confirm Yes/No to

stop blower. Select YES/NO by turning the push dial and press the push dial to make your choice.

ResMed Stellar 150 Client Version

On/Standby switch

A/C Power cord connection

Monitor

Setup

Info

Push

Dial

silver/

black

Start/

Stop

Page 1 ResMed Stellar 150 Client Version Battery life % Power Monitor source indicator Setup Alarm Info signal light Alarm Mute Push Dial silver/ black Start/ Stop On/Standby switch A/C Power cord connection How to power on/off When unit is plugged in and screen remains dark, flick the ON/Standby switch at the back of the unit next to the power cord inlet.
Page 2 To Access Parameter Menu 1. Press and hold Push Dial and Setup button together until screen displays the heading Clinical Mode 2. Notice the highlighted box at the bottom left of the screen that reads “5 Minutes Set Time” this indicates the time available to access parameter settings before the unit returns to Client Mode.
Page 3 Maintenance of Stellar 150 BiPAP Replace the air filter every six months (or more often if necessary). The air filter is not washable or reusable. Remove the air filter cover at the back of the device. Remove and discard the old air filter. Insert a new filter. Refit the air filter cover. Wipe the exterior of the device with a damp cloth (and mild detergent if needed).