Installation Instructions; Installation Of The Control Station On The Tractor - Vaderstad Rapid RDA 400S Original Instructions Manual

2

Installation instructions

2.1

Installation of the Control Station on the tractor

Figure 2.1
1 Be sure to install the control box securely in the tractor cab. Place the control box within the
field of vision while looking in the travelling direction. Install the bracket as shown in the il-
lustration.
Check for hidden cables before drilling holes in the tractor cab.
NOTE!
2 Connect the Control Station to the electrical socket on the tractor. If an electrical power outlet
is not available, extra wiring must be installed. Preferably use 6 mm² cable. Connect the cables:
Brown to positive (+) and blue to earth (-).
The polarity must not be reversed.
NOTE!
It is important to have good wiring connections, as a loose connection will prevent correct opera-
tion.
Do not use a cigarette lighter outlet,as the current consumption is up to 20 A.
Make sure that the connecting cable to the drill is not trapped under the rear window of the tractor
as this may cause damage. Use a hatch or a hole. Securely clamp the cable in the tractor cab. This
protects the Control Station from damage in case the connection cable has inadvertently not been
disconnected prior to unhitching the drill.
27.06.2011
ver.2
Figure 2.2
RDA 400S
17