Step 3: Inserting The Iphone Into The Safecase; Step 4: Powering On The Safecase - Privoro SafeCase User Manual

STEP 3: INSERTING THE IPHONE INTO THE SAFECASE

To insert your iPhone, the lock panel must be removed
from the rear of your SafeCase
attached, follow the instructions for removing the lock
panel (see: Removing the lock panel).
Attempting to insert your iPhone with the lock panel
in place may damage both the SafeCase and phone.
Insert your iPhone into the SafeCase using the
following steps:
1. Slide the base tray open: Place your forefinger on
the inside center of the base tray and slide the
base tray open (Figure 17). Inserting your iPhone
without lowering the base tray may damage the
SafeCase and iPhone.
Figure 17: Slide the base tray open
2. Insert the iPhone into the tray: Place your iPhone
head-first into the tray and then rest the phone
into the case (Figure 18).
Figure 18: Insert the iPhone into the tray
. If the lock panel is
TM
3. Push the base tray closed: Push up from the
bottom of the base tray until it fits tightly around
the bottom of your iPhone (Figure 19).
Figure 19: Push the base tray closed
4. Attach the lock panel: Place the hooks at the
bottom of the lock panel into the hook cradles on
the rear of the SafeCase. Then press the top of the
lock panel into the SafeCase until the latch snaps
the panel into place (Figure 20).
Figure 20: Attach the lock panel

STEP 4: POWERING ON THE SAFECASE

The SafeCase is in shipping mode when it arrives. To
power it on for the first time, connect the SafeCase
to a power source (charge-capable USB port or wall
charger) using the charging cable provided. The micro
USB split connects to the SafeCase and the USB-A
side connects to the power source (Figure 21). Once
powered on, both the corner indicator LEDs and
battery status LEDs will blink green five times.
Figure 21: Connect the SafeCase to a power source
6